Air Cooled Split Floor Standing Fancy Air Conditioner
Comfort Air cooled split air conditioners CSF series comprises of two sections.
A condensing unit for the outdoor installation An evaporator unit for the indoor installation.
Both sections are connected with refrigerant copper piping at site. These units are designed to provide maximum efficiency at tropical conditions. This unit is best suitable for installation in residential, commercial and industrial applications. The wide range of models provides even better choice to select a particular one for all individual applications.
This product is also available in specially design for hazard areas/cement factory standard. Industrial grade heavy gauge condensers and evaporator units designed on high ambient T3 conditions (+50C) ambient temperature, with 11-12 fins per inch for dusty environment.
Condenser motors and propeller fan blades designed with accurate air flow rate according to the capacities, motor winding with pure copper wire and fan blades manufacturing with aluminum powder coted sheet.
The weather proof design of condensing unit permits their installation outside the building, either on ground level or on rooftop.
The evaporator units are available in various designs, front body of floor standing unit manufacturing with stainless steel gold non magnetic for fancy look of air conditioning unit (Models CSF 500~CSF 2400 only) or at the floor in a separate free space.
The outdoor unit comprises of following parts: Compressor, condenser coil, condenser fan and motor and all required electrical and refrigerant controls/ accessories.
The indoor unit comprises of following parts: Evaporator coil, evaporator fan and motor, refrigerant control and operation control.
Component Details
Air Cooled Split Floor Standing Fancy Air Conditioner
Construction
- The unit is made from heavy gauge galvanized steel sheets. The sheets are degreased, de- rusted, phosphated and finished with electrostatic baked powder paint. This ensures excellent corrosion resistance and thus ensuring long life of the unit. The evaporator unit is provided with Close cell (Aeroflex) insulation to prevent any heat losses. Front body of floor standing unit manufacturing with stainless steel gold non magnetic for fancy look of air conditioning
Compressor
- All CSF series units consist of one or two hermetic or semi hermetic reciprocating/scroll Each compressor is provided with completely independent refrigerant circuit.
Evaporator Fan & Motor
- The evaporator fans are forward curved centrifugal double width double inlet type. The fans are statically and dynamically balanced for noiseless operation. The blower fan and motor is direct driven with single and double shaft arrangement with multiple
Evaporator and Condenser Coils
- The evaporator and condenser coils are made of seamless copper tubes and aluminum plate these fins are mechanically expanded for best fit & performance. These coils are tested for leakages under water at a nitrogen pressure of 250 & 450 psig respectively.
Air Filters
- Every unit is supplied with one set of 1” thick washable aluminum pre-filters. The filters of models CSF 500 to CSF 2400 are supplied loose for mounting inside duct or at return air
Electrical Control Panel
- The electrical control panel is provided inside the condensing unit. The control panel consists of phase failure relay, contactors, thermal overload relays, time delay relays(in multi compressors only) and fuses etc. The control panel can be provided for remote installation remote display installation at the front door of floor standing
Operation Switches and Thermostat
The unit is provided with front door electronic room thermostat. This thermostat is a digital programmable heating and cooling temperature control devices. The thermostat has operation switch for ON/AUTO , HEAT/OFF/COOL and 3-speed fan(optional)switch